In the VIPM - Options dialog box that appears, remove the checkmark from the Mass Compile VIs After Package Installation checkbox. Complete the following steps to disable Mass Compile:Ģ. I2C TOOLS FOR MAC INSTALLDisable Mass Compile when you install this driver to LabVIEW 2010 or later, because a broken VI appears when you enable Mass Compile. Install this driver by using VI Package Manager. When the slave FPGA clock is 80 MHz, the maximum master clock is 2 MHz. When the slave FPGA clock is 40 MHz, the maximum master clock is 1 MHz. NI Single-Board RIO hardware, NI 9401, NI 9402, and PXI modules work with the SPI slaves. NI Single-Board RIO hardware works with both the SPI and I2C masters, whereas NI 9401 works with the SPI masters and NI 9402 works with the I2C masters. This driver uses field-programmable gate array (FPGA) digital I/O lines to communicate with the SPI masters, the SPI slaves, and the I2C slaves. Windows users have been enjoying various awesome tools to help with their AVR development process like the Atmel Studio, Codevision AVR, WinAVR, IAR Embedded. The library is used by some of the tools, but can also be used by third. The tools were originally part of the lm-sensors project but were finally split into their own package for convenience. This driver acts as an SPI master, an I2C master, or an SPI slave. I2C TOOLS FOR LINUX This package contains an heterogeneous set of I2C tools for the Linux kernel as well as an I2C library. add yourself to the i2c group: sudo usermod -aG. append a new line with i2c-dev to /etc/modules: sudo nano /etc/modules. Alpha Station gives you the tools you need to quickly read and display Analog to Digital Values such as the MAX1069 connected to a 8-Channel Multiplexer to display. install i2c-tools: sudo apt-get install i2c-tools. Hardware Compatible with Linux and Mac (No Software) I2C Bus Speed of 38, 100, 200, 300, and 400KHz Please note that images above may contain product not included with purchase. This driver includes NI LabVIEW host code and LabVIEW FPGA code for the Serial Peripheral Interface (SPI) and Inter-Integrated Circuit (I2C) protocol communication engine. This needs to be done once all these changes will be remembered across reboots: enable I2C via the raspi-config Advanced Options menu: sudo raspi-config.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |